XBee-PRO® 900 RF Modules

- No configuration needed for out-of-the-box RF communications
- Common XBee footprint for a variety of RF modules
- Outdoor RF line-of-sight range up to 6 miles (10 km)
- Fast 156 Kbps RF data rate
- Supports sleep modes for increased battery life
- Product datasheet
XBee-PRO 900 embedded RF modules provide extended-range wireless connectivity to end-point devices. Supporting RF line-of-sight distances of up to 6 miles (with high gain antennas), these modules are ideal for extended-range wireless applications requiring low latency and increased data throughput.
Models
| Development Kits | North America: | International: | |
|
XBee-PRO DigiMesh 900 Development Kit w/ 4 XBee-PRO Modules
|
XBP09-DMDK $299 USD |
Not applicable |
|
| XBee-PRO 900 Embedded RF Modules | North America: | International: | |
|
XBee-PRO 900 extended range module w/ wire antenna
|
XBP09-DPWIT-156 |
Not applicable |
|
|
XBee-PRO 900 extended range module w/ RPSMA connector
|
XBP09-DPSIT-156 |
Not applicable |
|
|
XBee-PRO 900 extended range module w/ U.FL connector
|
XBP09-DPUIT-156 |
Not applicable |
Specs
Performance:
- Power output: 50 mW (+17 dBm)
- Indoor/Urban range: Up to 450 ft (140 m)
- Outdoor/RF line-of-sight range: Up to 1.8 miles (3 km), up to 6 miles (10 km) with high gain antennas
- RF data rate: 156 Kbps
- Interface data rate: Up to 230 Kbps software selectable
- Operating frequency: 900 MHz
- Receiver sensitivity: -100 dBm
Networking:
- Spread Spectrum type: FHSS (Frequency Hopping Spread Spectrum)
- Networking topology: Peer-to-Peer Mesh, point-to-point & point-to-multipoint
- Error handling: Retries & acknowledgements
- Filtration options: PAN ID, Channel, and 64-bit addresses
- Channel capacity: 8 hopping patterns on 12 channels
- Addressing: PAN ID, Channel, and 64-bit addresses
Power:
- Supply voltage:
- XBee-PRO: 3.0 - 3.6 VDC
- XBee footprint recommendation: 3.0 - 3.4 VDC
- Transmit current: 210 mA @ 3.3 V
- Receive current: 80 mA @ 3.3V
- Power-down sleep current: 60 uA @ 3.3V
General
- Frequency band: 902 - 928 MHz
- Interface options: 3V CMOS UART
Physical Properties
- Size: 0.960 in x 1.297 in (2.438 cm x 3.294 cm)
- Weight: 0.10 oz (3g)
- Antenna options: U.FL, Reverse Polarity SMA (RPSMA), or wired whip antenna
- Operating temperature: -40° C to +85° C (industrial)
Certifications
- FCC: Yes
- IC: Yes
- RoHS: Compliant
Documentation
Product Literature
Support Documentation
General Support Documentation:
- Getting Started Guide: XBee-PRO 900/ DigiMesh 900 OEM RF Modules
- Government Agency Certifications
- Mechanical Drawing: XBee / XBee Pro OEM RF Modules
- Product Manual: XBee-PRO 900/ DigiMesh 900 OEM RF Modules
- Users Guide: XCTU Configuration & Test Utility Software
- Mechanical Drawing: XBee / XBee Pro OEM RF Modules: RPSMA Variant
- Schematic: XBIB-R Interface Board, rev. 7B
- Schematic: XBIB-U Interface Board, rev. 4A
- Schematic: XBIB-R-DEV Interface Board, rev. 4B
- Schematic: XBIB-U-DEV Interface Board, rev. 3A